Rain & freeze sensor installation in Pearland
There's no reason to water during a Gulf Coast downpour. A rain and freeze sensor pauses your system automatically — and saves you money doing it.
Why every Pearland system should have one
We've all seen it — sprinklers running full blast in the middle of a thunderstorm. That's water (and money) straight down the storm drain, and on the Gulf Coast it happens a lot. A rain sensor tells your controller to skip the cycle when it's already wet.
A freeze sensor is just as useful here. When a hard freeze rolls through, the last thing you want is the system running and coating your driveway — and your backflow preventer — in ice. The sensor pauses watering until it warms back up.
Reasons to add one
Small device, real savings — and less wear on the whole system.
- Your sprinklers run during and after rain
- Water bills spike in the rainy months
- You want to stop over-watering automatically
- Your backflow keeps freeze-cracking each winter
- You're on a smart controller but have no sensor
- You just want to set it and forget it
Wired in and tested with your controller
We mount the sensor where it gets true exposure to rain and temperature — not tucked under an eave where it never reads correctly — and wire it into your controller so the system pauses on its own.
Wireless and wired options both work; we'll recommend the right one for your setup and confirm it actually interrupts a cycle before we leave. If you're on a smart controller, we'll make sure the sensor and the weather features work together instead of fighting each other.
- Wireless and wired rain sensors
- Combined rain + freeze sensors
- Mounted for accurate readings
- Integrated with any controller
- Tested to confirm it pauses a cycle
- Pairs with smart controllers
Tired of watering in the rain?
We'll add a rain and freeze sensor that pays for itself.
Prefer to type it out? Request a quote →